| Step | | Procedure & Parts & Tools |
| 1 |
|
Open Tank Lid
|
| 2 |
|
Using T-30 Torx, Loosen 2 screws on rubber buffers. Complete removal of screws is not needed.
| Torx T30 |
|
|
| 3 |
|
Once rubber buffers of loose, separate the lower plate from tank lid
|
| 4 |
|
On terminal block, locate Red and Black pump wires. Loosen set screws with small flathead screwdriver and remove wires from block.
| Screwdriver-flat tip |
|
|
| 5 |
|
Open tank again, and loosen the gray strain relief with a 17 mm wrench.
| Wrench-metric 17mm |
|
|
| 6 |
|
Once strain relief cap is loose, pull the pump wires through.
|
| 7 |
|
With cutters, free the pump wires by cutting the zip-ties down the solution hose.
| Wire cutters |
|
|
| 8 |
|
With Flathead, loose hose clamp by the pump and remove from hose. Reverse steps to install new pump.
| Screwdriver-flat tip |
|
|